Awc Setting - Sanyo VCC-ZM400P Instruction Manual

VIEW SETTING
White balance additional settings 3

AWC setting

1
VIEW SETTING 1
IRIS AUTO ‚
WHITE BALANCE AWC
SHUTTER OFF
MOTION OFF
APERTURE ON
GAMMA ON
1
Use the cursor button (j or l) to move the cursor to
AWC for WHITE BALANCE and press the SET button.
The AWC SETTING screen will appear.
2
With SET blinking for AWC LOCK, press the SET button.
SET will light and adjustment of white balance will begin. After
about 3 seconds, SET will begin blinking again, signaling that
adjustment is complete.
Note:
For even finer adjustment of coloration, choose SET for GO TO
MWB. White balance mode will become MWB for fine
adjustment. After fine adjustment with GO TO MWB, the white
balance mode will automatically switch to MWB.
Note: Full adjustment may not be possible with just one
activation of SET for AWC LOCK. In that case, press the
SET button again.
45
2
AWC SETTING
AWC LOCK
‚
GO TO MWB
‚
3
AWC SETTING
SET AWC LOCK
SET ‚ GO TO MWB
3
GO TO MWB setting
Use the cursor button (j or l) to move the cursor to
SET for GO TO MWB and press the SET button.
The MWB SETTING screen will appear and the "R" value will
be blinking.
4
Use the cursor button (d or c) to adjust the value for
"R" (red).
Available settings: 0 – 255
Note: The larger the number, the stronger red becomes.
5
Use the cursor button (j or l) to move the cursor to
"B", then use the cursor button (d or c) to adjust the
"Blue" value.
Available settings: 0 – 255
Note: The larger the number, the stronger blue becomes.
To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
4
MWB SETTING
SET (OFFSET)
SET ‚ R í---ú--+------ü
B í---ú--+------ü
70
66