Sync Setting (Sync); Power Source Synchronization (L-L) Setting - Sanyo VCC-ZM400P Instruction Manual

CAMERA ID SETTING
4
Use the cursor button (j or l) to move the cursor to
POSITION, and then press the SET button.
The camera ID will be displayed on one line.
CAMERA ID SETTING
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
0123456789 :-‚
ID CAM1????????????
POSITION SET ‚
PRESET OFF
MENU BACK
(Displaying the ID on 2 lines.)
1 Use the cursor button (d or c) to move the cursor to the
location in the ID field where the carriage return is wanted.
2 Use the cursor button (j l d c) to move the cursor to
the carriage return mark (y) at the lower right corner of
the character selection palette, and then press the SET
button.
5
Moving the on-screen title display position
Use the cursor button (j l d c) to move the title
display to the preferred position on the screen, then
press the SET button.
The CAMERA ID SETTING screen will reappear.
CAM1
Camera ID

SYNC SETTING (SYNC)

Default setting is internal synchronization (INT), so it does not
need to be set again. Follow the steps below to change the
setting to power source synchronization (L-L).

Power source synchronization (L-L) setting

1
MAIN MENU
LANGUAGE SET ‚
CAMERA ID OFF
SYNC INT
PRIVACY MASK SET ‚
LENS SET ‚
MIRROR OFF
VIEW SETTING 1 ‚
OPTION SET ‚
PRESET OFF
MENU END
1
Use the cursor button (j l d c) to select L-L for
SYNC, then press the SET button.
The L-L SETTING screen will appear.
2
Use the cursor button (d or c) to adjust the position
of the vertical synchronization indicator shown on the
screen.
The numerical value will change, allowing adjustment of
vertical synchronization.
To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
2
L-L SETTING
(V SYNC PHASE)
ú------+------ü 0
PRESET OFF
MENU BACK
12