Motion Masking Setting - Sanyo VCC-ZM400P Instruction Manual

VIEW SETTING

MOTION MASKING setting

Masking target objects that are not desired for detection (swaying trees, flickers of light , etc.) will prevent unwanted alarms from being
generated. This is done in the MOTION SETTING screen.
1
MOTION SETTING
SIZE SET ‚
MASKING ON ‚
SENSITIVITY SET ‚
ZOOM OFF
INTERVAL 5S
ALARM SIGN OFF
PRESET OFF
MENU BACK
1
Use the cursor button (j or l) to move the cursor to
MASKING, and then use the cursor button (d or c) to
select ON. Then press the SET button.
The MOTION MASKING screen will appear, and the mask
pattern will be blinking in the upper left corner of the screen.
2
Use the cursor button (j l d c) to move the mask
pattern to the target object that is not to be detected,
then press the SET button.
Repeat these steps to set mask patterns in other locations.
Note: To clear a mask pattern, press the SET button again on
the pattern.
2
MOTION MASKING
CONTINUE (ñ)
MOTION MASKING
CONTINUE (ñ)
3
Finishing motion pattern setting
Use the cursor button (j or l) to move a mask pattern to
the bottom area of the screen and continue holding it for 3
seconds. The PRESET and MENU items will appear on the
screen.
To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
50