Mwb Setting; Atw Setting - Sanyo VCC-ZM400P Instruction Manual

VIEW SETTING
White balance additional settings 1

MWB setting

1
VIEW SETTING 1
IRIS AUTO ‚
WHITE BALANCE MWB
SHUTTER LONG ‚
MOTION OFF
APERTURE ON
GAMMA ON
1
Use the cursor button (j or l) to move the cursor to
WHITE BALANCE, then use the cursor button (d or c)
to select a white balance type (e.g. MWB). Then press
the SET button.
The MWB SETTING screen will appear.
2
Use the cursor button (d or c) to adjust the value for
"R" (red).
Available settings: 0 – 255
Note: The larger the number, the stronger red becomes.
3
Use the cursor button (j or l) to move the cursor to
"B", then use the cursor button (d or c) to adjust the
"Blue" value.
Available settings: 0 – 255
Note: The larger the number, the stronger blue becomes.
To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
43
2
MWB SETTING
(OFFSET)
‚
R í---ú--+------ü
‚ B í---ú--+------ü
White balance additional settings 2

ATW setting

Automatic white balance settings are completed when ATW is
selected. However, white balance will not be suitably adjusted if a
bright light source or an excessively dark area from the
70
environment is in the image. In this case, the bright light source or
66
dark area should be masked so that it will not be detected.
1
VIEW SETTING 1
IRIS
WHITE BALANCE
SHUTTER
MOTION
APERTURE
GAMMA
1
Use the cursor button (j or l) to move the cursor to
ATW for WHITE BALANCE and press the SET button.
The ATW SETTING screen will appear.
2
Use the cursor button (d or c) to select ON for
MASKING, then press the SET button.
The ATW MASKING screen will appear with the mask pattern
blinking in the upper left corner of the screen.
2
ATW SETTING
AUTO ‚ MASKING
ATW ‚
OFF SMART ATW
OFF
ON ‚
ON
ON ‚
OFF