Parts Names And Functions - Sanyo VCC-ZM400P Instruction Manual

PARTS NAMES AND FUNCTIONS

Control
terminals
ZOOM
2
FOCUS
VIDEO OUT
1
1
Video output connector (VIDEO OUT: BNC type)
Connect this connector to a device such as a time lapse VCR or
monitor with a VIDEO IN connector.
2
Power indicator (POWER)
Comes on when the power to the camera is on.
Note: After connecting the power supply the POWER indicator
will blink for 5 seconds. During this time no adjustments
using the menus or any other operation are possible.
3
Cursor button (See p8)
j: Press this button to move the cursor up.
c: Press this button to move the cursor to the right, or to
turn the settings ON/OFF etc.
d: Press this button to move the cursor to the left, or to turn
the settings ON/OFF etc.
l: Press this button to move the cursor down.
3
SET
4
IN
COM
OUT
ALARM
RS485
POWER
5
A B G
AC24V
GND
6
DC12V CLASS 2 WIRING
4
SET button (SET) (See p8)
Connect the camera to the monitor, then press the SET
button for about 3 seconds to display the on-screen menu.
5
RS-485 control push-lock terminals (RS485, A, B, G)
Use a cable thicker than AWG22.
A: Twisted-pair cable terminal
B: Twisted-pair cable terminal
6
24 V AC or 12 V DC input terminals (AC 24 V, DC 12 V,
GND)
Lens cap
The cap is installed to protect the lens section. Remove the cap
when using the camera.
G: Ground terminal
4