Dview Angle Setting - Sanyo VCC-ZM400P Instruction Manual

LENS SETTING (LENS)
Day/Night mode operation from the system controller
The Day/Night setting (AUTO, COLOR and B/W) can be
switched using "CAMERA" operating range of the system
controller. Press the following buttons in the order given to
change the mode setting.
• COLOR mode:
"AUX" → "AUX" → "1" → "Enter" → "+" button
• B/W mode:
"AUX" → "AUX" → "2" → "Enter" → "+" button
• AUTO mode:
"AUX" → "AUX" → "3" → "Enter" → "+" button
31
VIEW ANGLE setting
D
The VIEW ANGLE setting should normally be left at "OFF".
1
MAIN MENU
LANGUAGE SET ‚
CAMERA ID OFF
SYNC INT
PRIVACY MASK SET ‚
LENS SET ‚
MIRROR OFF
VIEW SETTING 1 ‚
OPTION SET ‚
PRESET OFF
MENU END
1
Use the cursor button (j or l) to select SET for LENS,
then press the SET button.
The LENS screen will appear.
2
Use the cursor button (j or l) to move the cursor to
VIEW ANGLE, and then use the cursor button (d or c)
to select the setting (e.g. OFF).
Available settings:
• OVER: The image angle for images being monitored is set
to 1.05.
• OFF: This should normally be set to "OFF".
Note: This should normally be set to "OFF". However, vignetting
may occur in the corners of the images because of the
zoom position. This is not normally a problem, but if you
are concerned about it, change the setting to "OVER". The
vignetting will then be less apparent.
2
LENS
FOCUS MANU ‚
ZOOM SET ‚
DAY/NIGHT AUTO ‚
VIEW ANGLE OFF
PRESET OFF
MENU BACK