Signal Cable; Printer Cable - NEC MultiSync FP1350 Service Manual

Hide thumbs Also See for MultiSync FP1350:
Table of Contents

Advertisement

6-3. Connection

Printer Cable

Program Disk
AUTO ADJ PROGRAM
PART No. 599910403
1) Connect signal cable from target monitor to Auto ADJ I/F jig. (From here after, this is abbreviated "JIG".)
2) Connect Printer cable to JIG AND PC.
3) Power on the monitor, JIG and PC after set up the software for auto ADJ I/F jig in PC.
All adjustment for Size, Position and Distortion can be done from PC by using this jig.
Adjustment for Size, Position and Distortion for all preset signals can be done by selecting only one
specified ("80: TOTAL1 (1024*768(75))") signal.
Note: Distortion adjustment signal may differ from another type monitor in some cases.
In this case, use signal displayed on the screen menu.
Signal Cable from
target monitor
IBM PC or compatible
AUTO ADJ I/F JIG
PART No. 599910401(120V)
Fig 6-2 Connection
Video Signal Generator

Signal Cable

(for A Ver.)
5-28
Target Monitor

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MultiSync FP1350 and is the answer not in the manual?

This manual is also suitable for:

Fp1350-1Fp1350-1b

Table of Contents