NEC MultiSync FP1350 Service Manual page 59

3. Horizontal / Vertical Maximum Size Adjustment
3-1. Horizontal Maximum Size Adjustment
1) Receive signal 13.
2) Open Menu (S), TAG2 "V.SIZE" and adjust "+", "-" SW so that the vertical size is 297±5 mm. If not able to
set vertical size, open Menu (S), TAG2 "V.SIZE MAX", adjust the vertical size. And open Menu (S), TAG2
"V.SIZE" and adjust vertical size.
3) Open Menu (S), TAG3 "IN / OUT" and adjust "+", "-" SW to correct side pincushion distortion.
4) Open Menu (S), TAG1 "H.SIZE MAX.1", push "RESET"SW and make sure that "H.SIZE MAX.1" is set to 1.
5) Open Menu (S), TAG1 "H.SIZE MAX.1", and adjust "+", "-" SW so that video horizontal size may become
full with the bezel.
6) Receive signal 35.
7) Open Menu (S), TAG2 "H.POSITION", rough adjust so that video area may become in the center of the
screen.
8) Open Menu (S), TAG1 "H.SIZE MAX. 2", and push "EXIT" SW. It confirms that data on "H.SIZE MAX.1" are
0.
9) Open Menu (S), TAG1 "H.SIZE MAX. 2", and adjust "+", "-" SW so that video horizontal size may become
full with the bezel.
10) Push "EXIT" SW.
3-2. Vertical Maximum Size Adjustment
1) Receive signal 28.
2) Open Menu (S), TAG2 "V.POSITION" and adjust "+", "-" SW so that the picture is centered with in the
screen.
3) Open Menu (S), TAG3 "V.SIZE MAX", push "RESET"SW and adjust "+", "-" SW so that the vertical size is
297±3 mm.
4) Push "EXIT" SW.
Signal: No. 13 (MAC832*624) All white
Signal: No. 35 (H.SIZE) All white
Signal: No. 28 (V.MAX) All white
5-18