NEC MultiSync FP1350 Service Manual page 13

OSM TURN OFF: The OSM menu will stay on as long as it is in use. In the OSM Turn Off sub-menu,
you can select how long the monitor waits after the last touch of a button for the OSM menu to
disappear. The preset choices are 10, 20, 30, 60 and 120 seconds.
OSM LOCK OUT: This control completely locks out access to all OSM functions except Brightness
and Contrast. When attempting to activate OSM while in the lock out mode, a screen will appear
indicating that OSM controls are locked out. To activate the OSM Lock Out function, press PROCEED,
then press and hold down simultaneously. To deactivate the OSM Lock Out, press PROCEED,
then press and hold down simultaneously.
IPM™ System Off Mode:
NOTE: For standard computers and display cards you should keep the factory setting at ENABLE.
EDGELOCK CONTROL: Operating your monitor at a non-standard timing may cause images to
appear darker than normal or have color distortion. Use of the EdgeLock control will adjust images to
their normal state.
REFRESH NOTIFIER: A message will advise you if the refresh rate of the signal being applied to the
monitor by the computer is too low. For further information, please refer to your display card or system
manual.
Factory setting is OFF.
Information
Provides you with additional information which included the following:
DISPLAY MODE: Indicates the current mode and frequency setting of the monitor.
FITNESS TIPS: The fitness Tips provide you with helpful reminders to periodically rest your eyes.
You may select how frequently the remainders are displayed based upon your individual needs.
Select an interval from 15,30,45,60,90 or 120 minutes for the tips to appear. When the tips appear,
follow the advice of the tips and press EXIT to clear.
MONTOR INFO: Indicates the model and serial numbers of your monitor.
Enable: The IPM works normally, all stages of energy savings are
used.
Disable: The OFF MODE of the IPM is not used.
2-8