Table of Contents
Advertisement
4.3.11 Configuring OSD settings
The on-screen display of the PTZ movements, temperature, system time, etc. can be enabled or disabled.
1.
Open the display settings menu: Go to: MAIN MENUS g DOME SETUP g SYS PARAMETER SETUP g DISPLAY
SETUP
Move the cursor to DISPLAY SETUP using the direction buttons and click IRIS+ to enter.
2.
3.
Move the cursor to the target item and click IRIS+ and click up/down direction buttons to choose each display mode as ON
or OFF, and define each display time as 2 seconds, 5 seconds or 10 seconds.
Click IRIS+ button to confirm.
4.
Display the viewing direction
The camera displays a viewing direction code when you manually rotate the camera. Codes are shown in the table below.
Display
N
Indication*
North
* The north direction refers to the 0º angle (initial position).
The temperature display refers to the internal temperature of the camera.
Display settings
NE
E
Northeast
East
SECTION 4: USING THE OSD MENUS
SE
S
Southeast
South
36x PTZ Dome Camera User Manual
SW
W
Southwest
West
NW
Northwest
29
Advertisement
Table of Contents
