Table of Contents
Advertisement
Protective sticker
Protective foam
3.
Locate the DIP switches inside the camera.
There are two DIP switch groups, SW1 (for RS-485 network address) and SW2 (for RS-485 network baud rate). The address
setup for the camera must be unique for each device on the RS-485 network. However, the baud rate switched must be
NOTE
configured to the same baud rate used by the other devices on the network.
DIP switches
SW1: 1 .. 8
address switches
Remove protective foam
DIP switches
36x PTZ Dome Camera User Manual
SECTION 2: INSTALLATION
SW2: 1, 2
baud rate switches
9
Advertisement
Table of Contents
