Table of Contents
Advertisement
SECTION 4: USING THE OSD MENUS
Move the cursor to BLANK NUM and click IRIS+ to enter the editing mode.
a.
b.
Click the up and down direction buttons to select a mask number for configuration.
c.
Click IRIS+ again to confirm and exit the editing mode.
3.
Configure the position and size of the privacy mask.
Move the cursor to SET BLANK and click IRIS+ button to enter the editing mode as shown in the following figure.
a.
You can see a privacy mask on the live window.
b.
When the ADJUST BLANK POS message appears, use the direction buttons to shift the position of the privacy mask.
When you click the FOCUS+ button, the ADJUST BLANK SIZE message will appear. Click the up/down buttons to
c.
increase/decrease the height of the mask, and click right/left buttons to increase/decrease the width of the mask. Click
IRIS+ button to save the settings and return to the previous menu and you can see the mask turn to gray.
d.
To modify the mask, click IRIS+ button to enter the SET BLANK menu, then click IRIS+ button again to reconfigure
the mask.
The tilt range for configuring the privacy masks is from 0° to 70°.
NOTE
Enable or disable the privacy mask function: Open the BLANK STATUS submenu, then click the up and down
4.
direction buttons to set it ON or OFF. If no privacy mask is configured, you cannot set the status as ON.
Delete the privacy mask: You can enter the DELE BLANK menu to delete the current privacy mask.
5.
28
Set the Privacy Mask
Advertisement
Table of Contents
