Table of Contents
Advertisement
SECTION 2: INSTALLATION
SECTION 2
Installation
Before you start, check the package contents and make sure that the device in the package is in good condition and all the assembly
parts are included. Included are:
AC power supply
•
Installation guide (this user manual)
•
Mounting brackets (sold separately)
•
This section includes camera installation using a wall mount bracket (see "2.2 Camera wall mount installation" on page 11) and
ceiling mounting bracket (see "2.3 Ceiling mounting" on page 14). For other bracket types, use the procedures included here as
guidelines.
2.1 Setup the camera address and baud rate DIP switches
DIP switches inside the camera are used to manually configure the RS-485 device address and network baud rate. The device
address and baud rate can also be configured remotely through the OSD (on-screen display) using a control console, DVR or DVS.
See "SECTION 3 Getting Started" on page 16 and "SECTION 4 Using the OSD Menus" on page 19 for more information.
There are two DIP switch groups, SW1 switches 1 .. 8 (sets the RS-485 network address) and SW2 switches 1 and 2 (sets the
RS-485 network baud rate). The address setup for the camera must be unique for each device on the RS-485 network. However,
the baud rate switched must be configured to the same baud rate used by the other devices on the network. These switches are
accessible when the dome cover is removed. To setup the DIP switches, do the following:
1.
Loosen the two lock screws as shown in the following figure.
2.
Remove the lower dome and remove the protective foam and sticker shown below. Be very careful not to touch the camera
lens.
8
Back
box
Lock
screw
Lower
dome
Camera assembly
Lock
screw
Advertisement
Table of Contents
