Observint T5 Quick Installation Manual

T5 5MP HD-TVI PIR Turret Camera

Quick Installation Guide

The T5 HD-TVI turret cameras with passive IR (PIR) detection include a high sensitivity sensor with the
ability to send HD video across standard coaxial cable. This camera features:
5 MP Megapixel High Performance CMOS 2592 (H) × 1944 (V)
•
IR with 65' IR range
•
2.8 mm lens with an 102.94˚ field of view
•
-22° ~ +131°F temperature range
•
PIR detection range 23 feet with 120° detection angle
•
Compatible with R4, R8 and R16 Digital Video Recorders
•
Can be installed with optional junction box.
•
Mounting
base
Cable
guide
Bezel
Enclosure
Camera
module
Hole for
mounting
screw (3)
Camera drop cable connectors
www.observint.com
1
T5 camera
Mounting base
Power Connector
HD-TVI video
BNC connector
What's in the box
Camera assembly
•
Mounting hardware
•
Drill template
•
This instruction guide
•
What you need
To install the camera, you will need:
12 Vdc power source. See Specifications for wattage requirement.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Video and power extension cable
•
Compatible Digital Video Recorder (DVR) or HD-TVI video setup monitor (optional)
•
Installation
Before installation:
Make sure that the device is in good condition and all the assembly parts are included.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
•
Lens
provide the rated voltage and wattage for the camera. See the Specifications section.
During installation:
Camera Lens: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
•
PIR
array shield becomes soiled, clean it only with approved products. See the
Sensor
Power supply: Camera drop cable: The camera drop cable includes two connectors:
•
Video BNC connector: For transmission of the video signal across a coax (75 Ω) extension
—
cable to an HD-TVI compatible recorder.
Power connector: When applying power, observe the power polarity. See the picture to the
—
left for the connector polarity configuration.
Mount the camera
These cameras can be mounted on a wall or ceiling that has sufficient strength to support it. The video /
power drop cable from the camera can be routed either through mounting surface or through a cable guide
on the edge of the mounting base.
1. Unscrew the bezel from the mounting base, and then lift it off of the camera.
2. Separate the enclosure and the camera module from the mounting base.
section.
Cleaning
RS_T5_CQ
181219