Observint R5DHS 5MP HD-TVI Dome Camera Quick Installation Manual

R5DHS 5MP HD-TVI Dome Camera
Quick Installation Guide
The R5DHS HD-TVI dome cameras include a high sensitivity sensor with the ability to send HD video
across standard coaxial cable. This camera features:
5 MP Megapixel High Performance CMOS 2592 (H) × 1944 (V)
•
65' IR range
•
2.8 mm lens with an 102.94˚ field of view
•
-22° ~ +131°F temperature range
•
Compatible with R4, R8 and R16 Digital Video Recorder
•
Mounting base
Cover screw (3)
Dome-cover
assembly
Screw
holes for
anchoring
mounting
base (3)
Holes for
dome-cover
assembly
screws (3)
D5 camera without dome-cover assembly (top view)
Camera drop cable connectors
www.observint.com
1
Cable channel
Drop cable
Lens
IR array
D5 camera
Camera
module
and
gimbal
Power Connector
HD-TVI video
BNC connector
What's in the box
Camera assembly
•
Mounting hardware
•
Security wrench
•
Drill template
•
This instruction guide
•
What you need
To install the camera, you will need:
12 Vdc power source. See Specifications for wattage requirement.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Phillips #2 screwdriver
•
Video and power extension cable
•
Compatible Digital Video Recorder or HD-TVI video setup monitor (optional)
•
Installation
Before installation:
Make sure that the device is in good condition and all the assembly parts are included.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
•
provide the rated voltage and wattage for the camera. See the Specifications section.
During installation:
Camera Lens: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
•
array shield becomes soiled, clean it only with approved products. See the
Power supply: Camera drop cable: The camera drop cable includes two connectors:
•
Video BNC connector: For transmission of the video signal across a coax (75 Ω) extension
—
cable to an HD-TVI compatible recorder.
Power connector: When applying power, observe the power polarity. See the picture to the
—
left for the connector polarity configuration.
Mounting the camera
A D5 camera can be mounted directly to a wall or ceiling. The surface should support at least three times
the weight of the camera. The video and power drop cables from the camera can be routed either through
mounting surface or through a cable channel in the mounting base.
1. Use the security wrench provided to loosen the dome-cover assembly screws, and then separate it
from the mounting base.
Typical ceiling mounting
section.
Cleaning
RS_D5_CQ
181220