Connecting The Cables - Observint The BLACK Line BLK-PTZ36X User Manual

4. If the camera drop cable will be routed through the ceiling, mark the location of a hole for the camera drop cable. The drop
cable will be routed through the mounting bracket and can be routed either through the mounting surface or out the side of
the mounting bracket.
5. Drill holes in the mounting screws and hardware. Also, drill a 1 1/4" diameter hole in the mounting surface for the drop cable.
6. Route the camera drop cable through the mounting bracket, then clip the safety rope onto the loop in the mounting bracket.
Align
marks
7. Fit the camera coupling into the ceiling mounting bracket, then twist the bracket to align the marks on the bracket and the
camera back box. See the figure above.
8. Tighten the two lock screws on the ceiling bracket to secure the camera to the mounting bracket.
9. Feed the camera drop cable through hole drilled at the mounting location, then anchor the mounting bracket to the ceiling.
10. Continue installation with "2.4 Connecting the cables" on page 13.

2.4 Connecting the cables

1. Route network cables for video, 24 Vac power and ground, and RS-485 between the remote control device and power source
and your camera. Do not apply power to the 24 Vac cables before connecting them to your camera.
Bracket
Ceiling
Lock screw
Coupling
Back box
SECTION 2: INSTALLATION
Drop cable
36x PTZ Dome Camera User Manual
Safety rope
13