Table of Contents
Advertisement
2.2 Camera wall mount installation
Following the instructions below to install the camera using the BLK-PTZWB Wall Mount Bracket.
Instructions for mounting the camera with a BLK-PTZPM Pole Mount PTZ Bracket or BLK-PTZCM Corner Mount PTZ
Bracket are very similar. For these brackets, use the instructions below as a guide.
1.
If you did not setup the camera DIP switches using "2.1 Setup the camera address and baud rate DIP switches" on page 8,
remove the camera dome cover, remove the protective foam, then reinstall the cover. See Section 2.1 steps 1, 2 and 7 above.
2.
Determine the best mounting screws and hardware to anchor the mounting bracket with the camera to the mounting
surface. Use the following guidelines:
For cement wall mounting, use the expansion screw to anchor the bracket.
—
For wooden wall mounting, use self-tapping screw to anchor the bracket.
—
Make sure that the wall is strong enough to withstand more than 8 times the weight of the camera and the bracket.
—
3.
Using the mounting bracket as a template, mark the location of the mounting screw holes on the mounting surface. Also
mark the location of a hole for the camera drop cable. The drop cable will be routed through the mounting bracket and
through the mounting surface.
4.
Drill holes in the mounting screws and hardware. Also, drill a 1 1/4" diameter hole in the mounting surface for the drop cable.
5.
Apply two wrap of the thread tape provided onto the treads of the pendant adapter (see below)
Pendant adapter
set screw
Wrap with
thread tape
Pendant adapter
6.
Screw the pendant adapter onto the end of the mounting bracket. Tighten the set screw to secure the adapter to the bracket.
7.
Route the camera drop cable through the mounting bracket, then clip the safety rope onto the loop in the mounting bracket.
Attach pendant adapter to mounting bracket
SECTION 2: INSTALLATION
Bracket
Loop for
safety rope
Lock screw (2)
36x PTZ Dome Camera User Manual
11
Advertisement
Table of Contents
