Table of Contents
Advertisement
2.2 Camera wall mount installation
The camera can be wall mounted to any indoor or outdoor solid wall. The instructions below detail a wall mounting installation of
the camera. For ceiling and corner mounting installations, use the following as a guideline.
The wall must be thick enough to mount the expansion screws.
•
NOTE
The wall must be strong enough to withstand more than 4 times the weight of the dome and its accessories.
•
1.
Prepare the mounting surface for the camera and mounting bracket.
a.
Obtain the best fasteners for attaching the camera wall mount bracket to the mounting surface. The fasteners must fit
the wall mount bracket and should support at least eight times the weight of the camera and mounting bracket.
b.
Position the wall mount bracket in the location where you want to install it, then use it as a guide to mark the location
of the screw holes.
c.
Drill four screw holes according to the screw holes on the wall mount.
d.
Drill a 1-1/4" hole in the mounting surface between the mounting screws appropriate for the camera drop and
interface cables.
2.
Secure the camera onto the wall mount bracket as shown below:
a.
Route the camera drop cables through the wall mount bracket.
b.
Rotate the connector of the camera housing onto the wall mount bracket.
Loop for
safety rope
Set screw (2)
Wall mount installation
SECTION 2: INSTALLATION
36x PTZ IR Outdoor Camera User Manual
Screws (4)
11
Advertisement
Table of Contents
