Ac Settings; Table 5-15 Value Description Of Ac Settings - Emerson ACTURA Flex 48330 User Manual

Parameter Range
When Temp 1
or Temp 2 is Over
set to "Battery
Temp"
High
Low

5.7.7 AC Settings

1. The configuration interface is shown below:
Use "
select the parameter value. Press "ENT" to confirm and save.
2. The value description of the parameters is listed below:
Parameter Range Default
50V ~
OverVolt
300V
50V ~
LowVolt
300V
50V ~
UnderVolt
300V
3-phase,
Single
AC Input
Phase,
None
Default
10 C ~
50°C
100 C
10°C ~
50°C
100°C
-40°C ~
0°C
10°C
OverVolt:
LowVolt:
UnderVolt:
AC Input:
" or " " to select one page or one of the parameters, and "

Table 5-15 Value description of AC settings

The monitoring module will raise an alarm when
280V
the AC input voltage is higher than the "OverVolt"
The monitoring module will raise an alarm when
170V
the AC input voltage is lower than the "LowVolt".
The monitoring module will raise an alarm when
the AC voltage of an operating route is lower than
80V the "UnderVolt", but there will be no alarm when
the AC voltage of the standby route is lower than
the "UnderVolt"
Dependat
Set this parameter according to the actual situation. In a system with an AC
on
sampling board, you can only select "Single Phase" or "3-phase"; in a system
system
without an AC sampling board, you can select only "None".
type
ACTURA Flex 48330 Power System User Manual
Chapter 5 Operating SCU
Value description
When the detected battery temperature is
higher than the "Over", the monitoring
module will raise an alarm
When the detected battery temperature is
higher than the "High", the monitoring
module will raise an alarm
The monitoring module will raise an alarm when the
detected battery temperature is lower than the "Low"
240V
210V
200V
None
Value description
The "High"
must not be
higher than
the "Over"
" or " " to
The "OverVolt" must be
higher than the "LowVolt".
To avoid alrm disorder, it
is suggested to use the
default values
The "UnderVolt" must be
lower than the "LowVolt".
63