Setting System Parameters; Parameter Setting Method - Emerson ACTURA Flex 48330 User Manual

The maintenance operations over a single rectifier include: "DC ON/OFF", "AC
ON/OFF" and "Reset". The operation method is:
① Use "
rectifier serial No. Then press "ENT" to confirm. The bottom line of the page
displays the rectifier ID.
② Use "
" " or "
If the rectifier voltage is too high, you can select "Reset" to restore the output
voltage of that rectifier to normal.
6. There will be prompts as the confirmation of control commands. If the
maintenance operation is valid, system will prompt you press "ENT" to confirm and
execute the operation, or "ESC" to abort the operation. Otherwise, system will
prompt you the operation is invalid, and press "ESC" to quit.
Press "ESC" to return to the menu of higher level.

5.7 Setting System Parameters

Battery parameters are very important, for they are related to the life of battery.
Before delivery, the battery parameters have been initialized. Without any special
needs, you only need to reset the battery group number and battery capacity, and
accept the defaults for other parameters.

5.7.1 Parameter Setting Method

1. At any system information page, press "ENT" to enter the main menu.
" or " " to select the rectifier parameter, and "
" or " " to move the cursor to the maintenance operation area, and
" to select the value.
Press ENT to Run
Other Key Quit
No Maintain!
ESC Quit
MAIN MENU
status
Maintenance
Settings
ACTURA Flex 48330 Power System User Manual
Chapter 5 Operating SCU
" or " " to change the
53