System Configuration Registers; Table 6.2 Modify Registers; Table 6.3 Register Settings - Emerson Branson LPX Instruction Manual

6.4

System Configuration Registers

To access and modify the system configuration registers:
Table 6.2 Modify Registers
Step
1
2
3
4
The table below shows the register number along the description and parameters.
Table 6.3 Register Settings
Register
1
2
3
50
Press the Configuration Key two times while on rdy screen.
Use the Up and Down keys to select the register to modify, then press the
Enter key to confirm the selection.
Use the Up and Down keys to set the desired parameter, then press enter
to confirm the entered value.
Press the ESC key to return to the rdy screen.
Description
Software Version
Shows the current software version installed on the
unit.
Panel Trigger
In OFF position, the user must control the Start/
Stop function through the 9-pin D-Shell connector
on the back of the power supply enclosure. This
mode disables the Start/Stop key from starting a
cycle, but will always permit it stopping a cycle. Test
key is not disabled.
In ON position, the Start/Stop function is controlled
at the front panel of the unit only. The Start/Stop
function is disabled at the 9-pin D-shell connector at
the back of the LPX power supply enclosure.
Pulse Start
In ON position the user must press the Start/Stop
key for a minimum duration of 10 ms to initiate a
cycle. After 10 ms the Start/Stop key can be
released allowing the system to continue through
the intended cycle. Releasing and pressing the
Start/Stop key again will abort the current process
cycle.
In OFF position the user must continue to hold the
Start/Stop key throughout the duration of the
process cycle. If the Start/Stop key is released
during a cycle then the cycle is aborted.
NOTICE
In both modes the Start/Stop key must be released
before the next cycle can be started.
Action
N/A
0 (OFF) Default
1 (ON)
0 (OFF) Default
1 (ON)
100-412-196 REV. 06
Parameters