Configuring Record/Capture Schedule - HIKVISION DS-9204/08/16HWI-ST User Manual

User Manual of Digital Video Recorder

5.2 Configuring Record/Capture Schedule

Purpose:
Set the record schedule, and then the camera automatically starts/stops recording according to the configured
schedule.

In this chapter, we take the record schedule procedure as an example, and the same procedure can be applied
to configure schedule for both continuous recording and capture. To schedule the automatic capture, you
need to choose the Capture tab in the Schedule interface.

We use the interface of DS-9000HFI-ST series (unless otherwise stated) as example to describe the following
settings.
Steps:
1. Enter the Record Schedule interface.
Menu > Record > Schedule
Recording triggered by
motion detection or alarm

The VCA settings and VCA event triggered recording / capture are supported by the analog cameras
01~04 or the smart IP cameras connected to the HDVR only.

To enable Motion, Alarm, M | A (motion or alarm), M & A (motion and alarm) and VCA (Video
Content Analysis) triggered recording, you must configure the motion detection settings, alarm input
settings or VCA settings as well. For detailed information, refer to Chapter 8.1, Chapter 8.2 and
Chapter 8.5.
2. Click the Record tab, select the camera for schedule settings, and then check the checkbox of Enable
Figure 5. 9 Record Schedule
Normal recording
Recording triggered
by motion detection
Delete the schedule
Figure 5. 10 Record Type
75
Recording triggered
by all event detection
Recording triggered
by alarm
Recording triggered
by motion detection
and alarm