Configuring Record Schedule - HIKVISION DS-7616NI-E2/16P User Manual

DS-7600 Series NVR User's Manual
Note:
The redundant record is to decide whether you want the camera to save the record files or captured
pictures in the redundant HDD. You must configure the redundant HDD in HDD settings.
Note:
You must click the Apply button after adjusting the configuration of each tab before you move on to
adjust another one.
Note:
Event recordings are recordings that are triggered from motion detection and/or from an external alarm.
Note:
If an event occurs during Continuous recording, the frame rate will automatically switch to that set for
Event recording.
Note:
For holiday settings, you can refer to Page 46.
Note:
At least 2 hard disks must be installed when you want to set a HDD to Redundancy mode and one of them
with R/W property.

Configuring Record Schedule

A record schedule allows you to schedule multiple time periods per day for recording. Setting up a record
schedule will allow you to further conserve disk space by recording only during the time periods you
would like to record at.
Steps:
1. Enter the Schedule menu, shown in Figure 30 by going to Menu > Recording Configuration >
Schedule.
Figure 57 Record Schedule Configuration Menu
62