Step 2
Step 3
Configuring Gatekeeper Settings
If your SCOPIA XT Series works in conjunction with a gatekeeper, configure gatekeeper-related
settings. Use this section to configure gatekeeper settings.
This procedure completes the basic system configuration.
Before you begin
This procedure is performed as part of the basic configuration after
Settings" on page
Procedure
Step 1
RADVISION | User Guide for SCOPIA XT4000 Series Version 3.0
Configure the IP addresses.
Press Close to exit the quick setup wizard.
12.
Set the Enabled list to Yes.
Figure 3-5
Defining IP Settings
"Configuring Network
Getting Started | 13