Table of Contents
Advertisement
Move the cursor to TASK ACTION and click the IRIS+ to enter edit mode.
a.
b.
Click the up and down direction buttons to select the task action from preset 1 to 8, pattern 1 to 4, patrol 1 to 8,
panning scan, tilting scan, random scan, frame scan, panoramic scan, day mode, night mode or none.
Click IRIS+ again to confirm and exit edit mode of this column.
c.
5.
Set the task time.
Move the cursor to TASK TIME and click IRIS+ to enter edit mode.
a.
b.
Click the left and right direction buttons to position the cursor to WEEK, START (H-M) and END (H-M).
c.
Click the up and down direction buttons to select the specific start time and end time to run the task. The weekday
can be set to be from Monday to Sunday or Whole Week.
d.
Click IRIS+ to confirm and close the menu.
4.8.2 TASK 2: Delete the task.
To delete a task, move the cursor to TASK CLEAR and click IRIS+ to delete the time and action of the current task. Click IRIS+
again to confirm the settings and exit.
4.9 Configuring Zones
A ZONE is an area where panning and tilting is performed within left, right, up and down limit stops. You can configure the zones on
ZONES submenu. A zone is defined when the targeted surveillance scene is limited. You can configure up to 8 zones.
SECTION 4: USING THE OSD MENUS
Set the Time Task
36x PTZ IR Outdoor Camera User Manual
41
Advertisement
Table of Contents
