Click IRIS+ to enter edit mode.
2.
Click the left/right buttons to move the cursor on the current password and click up/down or FOCUS+ or FOCUS- buttons to
3.
choose the number.
Click the right direction button to move the cursor to INPUT PW AGAIN, then enter the password again.
4.
5.
Click IRIS+ to save the changes and close the menu.
Open the START USING submenu and switch the status to ON, then click IRIS+ to save the setting.
6.
4.10.2 Restoring default dome settings
You can reset all dome settings to factory default parameters as shown in the table below. Dome settings include mostly PTZ
parameters, alarm parameters, and some system settings, for example, the dome address.
1.
Open the default dome settings menu. Go to MAIN MENUS g RESTORE DEFAULTS
Click IRIS+ to restore the dome settings to the values shown in the table below, or click IRIS- to exit.
2.
Table 5. Default dome settings
Set the password
Parameters
Dome address
Baud rate
120Ω matching resistance
Soft address
SECTION 4: USING THE OSD MENUS
Default Value
0
2400 bps
Off
Off
36x PTZ IR Outdoor Camera User Manual
45