Table of Contents
Advertisement
SECTION 4: USING THE OSD MENUS
When you click the FOCUS+ button, the ADJUST BLANK SIZE message will appear. Click the up and/or down buttons
c.
to increase/decrease the height of the mask, and click right/left buttons to increase/decrease the width of the mask.
Click IRIS+ button to save the settings and return to the previous menu. The mask will turn to gray.
To modify the mask, click IRIS+ button to open the SET BLANK menu, then click IRIS+ button again to reconfigure
d.
the mask.
The tilt range for configuring the privacy masks is from 0° to 70°.
NOTE
Enable or disable the privacy mask function: Open the BLANK STATUS submenu, then click the up and down
4.
direction buttons to set it ON or OFF. If no privacy mask is configured, you cannot set the status as ON.
Delete the privacy mask: Open the CLEAR BLANK menu to delete the current privacy mask.
5.
4.4 Configuring PTZ control parameters
You can configure panning, tilting and zooming movements, and configure PTZ control functions including presets, patrols,
patterns, etc. for the camera.
4.4.1 Configuring PTZ parameters
Open the PTZ configuration menu. Go to MAIN MENUS g DOME SETTINGS g MOTION PARAMETER
32
PTZ configuration menus
Advertisement
Table of Contents
