Observint BLK-PTZ36XIR User Manual page 29

Using an internet browser connected to a DVR, click the left and right direction buttons in the PTZ control panel to page up
NOTE
or page down when more than one page is available.
Descriptions of system parameter configuration:
Dome address settings
•
TASK 1: Set the soft address of the camera.
If the SOFT ADDR ACTIVE is set ON, the soft address is the valid address for connecting the camera. The SOFT
ADDRESS ranges from 1 to 255.
If the SOFT ADDR ACTIVE is set as OFF, the hard address set by the DIP switch is the valid address of the camera.
TASK 2: Set the broadcast address of the camera.
When the BROADCAST ADDRESS is set to ON, the control devices with address 0 can control the camera remotely
regardless of the address of the camera.
With this function on, a control device with address 0 can control all PTZ cameras connected to it. This function is
usually used for debugging.
Soft baud rate settings
•
If the SOFT BAUD ACTIVE is set to ON, the soft baud rate is the valid baud rate for the camera. You can select either 2400,
4800, 9600 or 19200.
If the SOFT BAUD ACTIVE is set to OFF, the baud rate is set by the SW2 DIP switches.
System Information settings
36x PTZ IR Outdoor Camera User Manual
SECTION 4: USING THE OSD MENUS
21