Table of Contents
Advertisement
SECTION 4: USING THE OSD MENUS
Click the direction buttons in the PTZ panel to configure the left limit stop. Click IRIS+ to confirm.
c.
d.
Follow the steps above to configure the right, up and down limit stops on the menu. The new limit stops will
overwrite the existed ones.
e.
You can clear the defined limit stops. Click IRIS+ to enter CLEAR STOPS, then click IRIS+ again to clear the stops.
ELEVATION SET. Set ELEVATION SET to ON to increase the elevation angle range of the camera or set it to OFF to disable the
•
function. The range of the elevation angle is 0 ~ 90° by default. It changes to -2° ~90° when the ELEVATION SET is enabled.
4.5 Configuring Presets
A preset is a predefined direction. For the defined preset, you can click the calling button to move the camera to that direction.
4.5.1 TASK 1: Set a preset
To set a preset direction:
Open the preset configuration submenu: Go to MAIN MENUS g DOME SETTINGS g PRESETS
1.
2.
Choose the preset number:
Move the cursor to PRESET NUM and click IRIS+ to enter.
a.
b.
Click the up and down buttons to mark the preset number you want to edit. If the preset was defined, the preset label
is listed under the number; if it has not been defined, the label UNDEFINED is shown under the number.
34
Presets configuration men
Advertisement
Table of Contents
