Table of Contents
Advertisement
SECTION 4: USING THE OSD MENUS
4.3.8 TASK 9: Configure the image flip
If you enable IMAGE FLIP function, the image will be flipped diagonally along its central axis, shown as the mirror reflection of the
image.
4.3.9 TASK 10: Configure the INIT LENS
Enable INIT LENS to trigger a spontaneous lens initiation to ensure the normal operation.
4.3.10 TASK 11: Configure noise reduction
To reduce the noise in the image, you can set the NOISE REDUCE to LOW, HIGH, MIDDLE, or OFF.
4.3.11 TASK 12: Configure the image quality
Use the following parameters to improve the image quality as needed:
Wide Limit. Set the wide limit ON can limit the minimum zoom of the lens.
Chroma suppress: Set the CHROMA SUPRESS to ON can suppress color noise. This option can produce a clearer and higher
quality image in the low luminance environment.
Saturation: Saturation indicates the brightness of a color. The higher the saturation, the brighter the color is.
Contrast: Contrast is the measure of the difference between the darker and lighter parts of the image.
HLC (High Light Compensation). Set HLC to ON to brighten dark area and darken the highlight area of the image.
HR Mode: Set the HR MODE to ON to heighten the resolution. Switch it OFF to disable the function, which can avoid cross
color of the image.
4.3.12 Configuring Privacy Mask
Privacy mask enables you to cover specific areas on the live video to block these from appearing in live view and recorded video. The
masked areas can move with the panning/tilting movements and automatically adjust their size when the lens zoom changes.
1.
Open the privacy mask configuration submenu. Go to MAIN MENUS g DOME SETUP g PRIVACY SETUP
30
Advertisement
Table of Contents
