Table of Contents
Advertisement
SECTION 2: INSTALLATION
Black
24 Vac
Yellow/Gr. Ground
Red
24 Vac
Yellow
RS-485 +
Orange
RS-485 –
Video (BNC)
3.
Connect the network power and ground, RS-485, and video cables to the remote control device and 24 Vac power source.
4.
Connect the video output and RS-485 and video output cables to your network extension cables. Connect the other end of
these cables to a remote control device, such as a DVR.
5.
When power is applied to the camera, a system information display will appear for 2 minutes on top of the live video image
from the camera. Verify that the information on the display is intelligible.
6.
Verify that the live video from the camera is clear.
7.
Go to "SECTION 3 Getting Started" on page 15 to continue with camera setup using the OSD.
14
Label
Label
Drop cable connections
Typical System Information display
Drop cable
Advertisement
Table of Contents
