Connecting The Power Cord - Kyocera FS-2020D Operation Manual

Connecting and Printing

Connecting the Power Cord

Install the printer close to an AC wall outlet. If an extension cord is used, the
total length of the power cord plus extension should be 5 meters (16 feet) or
less.
Note Ensure the printer's power switch is off. Only use the power
cord supplied with the printer.
1
Connect the power cord to the Power Cord Connector at the rear of
the printer.
2
Connect the other end of the power cord to a power outlet.
3
Press the Power Switch to On ( | ). The printer begins to warm up.
IMPORTANT If you install the starter toner container and switch
on the power, after a moment the message Please
wait(Adding toner)
switched on after toner installation, there will be a delay of
approximately 15 minutes before the printer gets ready to print.
Once the [Ready] indicator lights, printer installation is complete.
is displayed. When the printer is first
4-3