Kyocera FS-2020D Operation Manual page 162

>>Duplex
? Off
>>Paper Mismatch
? On
7-62
Duplex (Duplex printing error detection setting)
If the error detection setting for duplex printing has been turned On, and
you attempt to print onto a paper size and paper type that cannot be
used for duplex printing, the Duplex disabled Press GO error
message will be displayed and printing will stop. The default settings is
Off.
On • To print onto one-side of the paper only when this
message is displayed, press [GO].
• Press [Cancel] to cancel the printing itself.
Off • To print onto one-side of the paper.
1
Press while >Error Handling > is displayed.
2
Press or repeatedly until >>Duplex appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Paper Mismatch (Detection settings for paper size/type errors
when the paper source is fixed)
This interrupts printing by indicating Paper Mismatch when the paper
sizes and/or types do not match between a print job and a paper source.
This can be disabled if you want to continue printing even if the paper
size or type you specified is different from the fixed paper source. The
default setting is On.
Note This setting does not relate to the Size Error. The Size
Error will be indicated when the Paper Size Dial and the actual
paper size do not match. For details on Size Error, refer to Error
Message of Troubleshooting.
1
Press while >Error Handling > is displayed.
2
Press or repeatedly until >>Paper Mismatch appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
On: stops printing and an error message appears
Off: continues printing
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
or .
or .
Using the Operation Panel