Kyocera FS-2020D Operation Manual page 174

>>HTTPS
? Off
>IPSec
>IPSec
? Off
7-74
HTTPS (SSL Server HTTPS setting)
HTTPS (Hyper Text Transfer Protocol Secure) is a protocol that adds
SSL data encryption, message authentication and a digital signature
function to the HTTP protocol used for data transfer between WWW
servers and clients.
S-HTTP is a similar protocol, but HTTPS differs in that it uses SSL.
The default setting is Off.
1
Press while >SSL Server On > is displayed. >>HTTPS
appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
The default setting is Off.
Note Check with your network administrator when selecting
network settings.
1
After entering the administrator ID and password, press
repeatedly until >IPSec appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using
4
Press [OK].
5
Press [Menu]. The display returns to Ready.
Security Level (Security level setting)
Security Level is primarily a menu used by service personnel for
maintenance work. There is no need for customers to use this menu.
or .
or .
Using the Operation Panel
or