Kyocera FS-2020D Operation Manual page 151

>>DHCP
? Off
>>IP Address
000.000.000.000
Using the Operation Panel
4
Select On or Off using
5
Select On and press [OK]. The display changes to the settings
shown below.
DHCP (DHCP setting)
DHCP (Dynamic Host Configuration Protocol) is the protocol that
assigns the information required to establish a network connection when
a host attempts to connect to the network (Internet). This information
includes the IP address of the local node and the default router (the
router in the host's own network system) and the DNS (Domain Name
System) server. DHCP is an extension of the BOOTP (Bootstrap) startup
protocol.
1
Press while >TCP/IP On > is displayed.
2
Press or repeatedly until >>DHCP appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
IP Address (IP address setting)
An IP address is the address of a network device such as a computer
and is included in IP packets as needed for the sending and receiving of
Internet data (IP packets). (IP addresses can be either destination
addresses or source addresses.)
Specifically, an IP address is a bit string consisting of a host address (or
host section) that identifies a computer (host) connected to the Internet
and a network address (or network section) that identifies the network to
which that computer belongs (or more specifically, the computer's
network interface). Bit strings (IP addresses) that are unique throughout
the entire Internet system are allocated to each computer or interface.
The IP addresses currently used on the Internet (IPv4) have a fixed
length of 32 bits.
Note When you enter the IP address, be sure to set the DHCP
setting to Off.
1
Press while >TCP/IP On > is displayed.
2
Press or repeatedly until >>IP Address appears.
3
Press [OK]. A blinking cursor (_) appears.
4
Press or to increase or decrease, respectively, the value at the
blinking cursor. You can set any value between 000 and 255. Use
and to move the cursor right and left.
5
Display the desired IP address and press [OK].
6
Press [MENU]. The display returns to Ready.
or .
or .
7-51