Kyocera FS-2020D Operation Manual page 136

>Paper Feed Mode
? Auto
7-36
Paper Feed Mode (Setting the paper feed source)
This mode specifies how the paper should be fed once the paper feed
source and paper type have been chosen. If Auto is selected, the printer
searches for a paper feed source that matches the paper size and type,
and paper is then delivered from that source. If Fixed is selected and
there is no matching paper feed source, handling proceeds as specified
by Paper Mismatch for Error Handling. For details on paper
feeding when Fixed is selected, refer to Paper Mismatch (Detection
settings for paper size/type errors when the paper source is fixed) on
page 7-62. The default setting is Auto. To change the settings, follow
the steps described below.
1
Press while Print Settings > is displayed.
2
Press or repeatedly until >Paper Feed Mode appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Press or until Auto or Fixed appears.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
When the Paper Runs Out During Printing
When Paper Feed Mode is set to Fixed, if the paper in the cassette
runs out during printing, Load Cassette 1 is displayed and the printer
stands by. In this event, either replenish the paper in the empty cassette
or use the procedure below to print from another paper source.
1
While Load Cassette 1 is displayed, press
until Use alternative? appears.
2
Press or repeatedly until the desired paper source and size
appears.
Each time you press
size that can currently be fed from the MP tray appears.
3
Press [OK]. Printing continues.
or , another paper cassette or the paper
Using the Operation Panel
or repeatedly