Kyocera FS-2020D Operation Manual page 90

Message
MemoryCard err##
Press GO
MemoryCard err20
Missing
developer unit
No multi copies
Press GO
Original toner
installed
Paper jam
###############
Paper loading
Paper path error
Print overrun
Press GO
RAM disk error##
Press GO
Replace toner
Clean printer
Size error
(Cassette) / (A4)
Toner low
Top tray
paper full
6-8
Corrective Action
A CompactFlash card error has occurred. Look at the error code given in place of ## and
refer to CompactFlash (CF) Card and USB Flash Memory Errors on page 6-10. To ignore the
CompactFlash card error, press [GO].
The CompactFlash card is accidentally inserted and removed from the printer's slot during
the printer is on. Turn the power switch off, insert the CompactFlash card, and then turn on
the printer again.
The developer unit is either not installed or incorrectly inserted. Insert the developer unit
securely.
Multiple copies cannot be printed because the RAM disk is disabled or the hard disk is not
installed. There is no available RAM disk or hard disk space. Delete unnecessary files. Press
[GO] to print error report.
Displayed when the installed toner is the original Kyocera product.
A paper jam has occurred. The location of the paper jam is indicated in place of the #'s. For
details, refer to Clearing Paper Jams on page 6-12.
The selected cassette is being prepared. (FS-2020D/3920DN/4020DN only)
When one or more optional feeders are installed, this message will appear if any of the paper
feeders or the printer cassette upper than the selected one is not properly closed.
The print job transferred to the printer was too complex to print on a page. Press [GO] to
resume printing. (A page break may be automatically inserted in some places.)
You can abandon printing by pressing [Cancel].
If Auto Error Clear is set to On, printing will be automatically resumed after a preset period of
time.
A RAM disk error has occurred. Look at the error code given in place of ## and refer to
Storage Error Codes on page 6-10. To ignore the RAM disk error, press [GO].
Toner has run out in the toner container. Replace the toner container using a new toner kit.
The printer does not operate when this message is displayed.
The paper size of the actual paper on which the print job was printed is shorter than the
intended paper size (the paper size specified in the paper source or specified by the user).
This error is released to restart paper supply either by placing the requested size paper in the
requested paper source or by matching the paper size setting for the paper supply to the
actually printed paper size.
You can also temporarily restart paper supply by pressing [GO]. At the same time
[ATTENTION] indicator will light up and [READY] indicator will start flashing.
Replace the toner container using a new toner kit.
The top tray has become full. You must remove all printed pages from the top tray. When the
printer detects that the top tray is empty again, the printer will continues printing into the top
tray.
Troubleshooting