Kyocera FS-2020D Operation Manual page 141

>>KC-GL Page Set
? [SPSZ]
>Font Select
Internal
>> I000
>>?I000
>Font Select
Internal
Using the Operation Panel
3
Press [OK]. A blinking question mark (?) appears.
4
Press or
B2, B1, B0, and SPSZ) is displayed. When selecting SPSZ, printing
will be done with the paper size specified by the PRESCRIBE SPSZ
command.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Font Select (Selecting the default font)
You can select the default font. The default font can be one of the
internal fonts or a font that is downloaded to the printer memory or stored
on CompactFlash card, or hard disk.
In this menu, you can also set the type and pitch for Courier and Letter
Gothic; as well as to print a font list.
1
Press while Print Settings > is displayed.
2
Press or
>
3
To select an internal font, make sure that Internal is displayed
and press . The display changes. If Internal is not displayed, press
[OK], then press
To select an optional font, press [OK] while >Font Select > is
displayed. Press
press [OK]. Press
You can perform this operation only when optional fonts are installed
in the printer.
The letter before the number indicates the location of the font, as
shown below.
I: Internal font
S: Soft (downloaded) font
M: Fonts in optional CompactFlash card
H: Fonts in RAM disk or optional hard disk
4
Press [OK]. A blinking question mark (?) appears.
5
Press or
font numbers of the internal fonts, refer to Print Fonts List on page 7-
15.
6
When the desired font is displayed, press [OK].
7
Press [MENU]. The display returns to Ready.
Selecting Regular or Dark Courier/Letter Gothic
Courier or Letter Gothic font thickness can be selected as Regular or
Dark. In the procedure below, it is assumed that Courier is selected. The
procedure is the same for Letter Gothic.
1
>
Press while Print Settings > is displayed.
2
Press or
repeatedly until the desired page size (A2, A1, A0, B3,
repeatedly until >Font Select > appears.
or until it appears.
or repeatedly until Option appears and then
next to display the font selection shown above.
repeatedly until the desired font number appears. For
repeatedly until >Font Select > appears.
7-41