Kyocera FS-2020D Operation Manual page 89

Message
Illegal Account
Press GO
Install MK
Job not stored
Press GO
Job restricted
Press GO
KPDL error ##
Press GO
Load Cassette #
/
(A4) (PLAIN)
Load MP Tray
/
(A4) (PLAIN)
Low security
Match envelope
switches
Memory overflow
Press GO
Troubleshooting
Corrective Action
This message is displayed when the Job Accounting function is enabled and no account is
set for a transmitted print job or the specified account is not registered (the incorrect account
is set). To return the printer to the print-ready status, press [GO].
For more information, refer to Job Accounting (Job Accounting selection/setting) section in
the Advanced Operation Guide.
Replace Maintenance Kit which is displayed on the message display. Replacement of the
maintenance kit is necessary at every 300,000 pages of printing and requires professional
servicing. Contact your service technician.
Printing using the Job Box function failed because there was insufficient space available on
the hard disk or RAM disk, or because the RAM disk was disabled when demounting the hard
disk. To print an error report and return the printer to the print-ready status, press [GO].
This message is displayed when printing was attempted, despite the Job Account function
being on with Restriction applied as the job limit for each job account.
To return the printer to the print-ready status, press [GO].
For more information, refer to Job Accounting (Job Accounting selection/setting) section in
the Advanced Operation Guide.
Current print processing cannot continue because of occurrence of KPDL error which is
categorized by ##. To print out an error report, display >>Error Report from the menu
system, and select On. Press [GO] to resume printing. You can abandon printing by pressing
[Cancel].
If Auto Error Clear is set to On, printing will be automatically resumed after a preset period of
time.
The paper cassette matching the paper size and paper type of the print job is empty. Load
paper into the paper cassette as displayed in place of #. Printing resumes automatically.
If you want to print from a different paper source, press
source, and then press [OK].
When you press [MENU], Paper Settings > appears. Press
size and type of the paper source. Press [OK] to display Use alternative? and then
press [OK]. Printing starts using the specified the paper source.
There is no paper cassette installed in the printer that matches the paper size and paper type
of the print job. Set paper in the MP tray. Printing resumes automatically. (Note that feeding
the paper having a paper size which does not match the current paper size from the MP tray
can cause paper jam.)
If you want to print from a different paper source, press
source, and then press [OK].
When you press [MENU], Paper Settings > appears. Press
size and type of the paper source. Press [OK] to display Use alternative? and then
press [OK]. Printing starts using the specified the paper source.
This message is displayed when Low was selected in Security Level.
Displayed when either of the envelope switches is not pressed. To print on the envelope,
press the both switches. (FS-2020D/3920DN/4020DN only)
The total amount of data received by the printer exceeds the printer's internal memory.
Try adding more memory. Press [GO] to resume printing. You can abandon printing by
pressing [Cancel].
If Auto Error Clear is set to On, printing will be automatically resumed after a preset period of
time.
or to select the alternative paper
or to select the paper
or to select the alternative paper
or to select the paper
6-7