General Information - Kyocera FS-2020D Operation Manual

9-2

General Information

This chapter explains the connector specifications of parallel, USB, and
network interfaces.
Parallel Interface
The printer provides high-speed data transmission on a parallel
interface.
Note Use a parallel interface cable that complies with the IEEE
1284 standard.
USB Interface
This printer supports the Hi-Speed USB. USB (Universal Serial Bus)
interface specifications are as follows.
Specifications
Basic specification
Complies with the Universal Serial Bus Specification Revision 2.0.
Connectors
Printer: B-type receptacle (female) with upstream port
Cable: B-type plug (male)
Cable
Use a shielded cable that complies with USB 2.0 (Hi-Speed USB) and
not longer than 5 meters (16 feet).
Transfer Mode
High speed (480 Mbps maximum)
Full-Speed (12 Mbps maximum)
Power Control
Self-power device
Interface Signals
USB Connector Pin Assignment
Pin Signal
1 Vbus
2 D-
3 D+
4 GND
Shell —
Description
Power supply (+5 V)
Data transmission
Data transmission
Signal ground
Shield
Computer Interface