Hose Installation 2 WD & 4 WD
Boom Hoses / Tank Hoses:
1.
Install Hose To Pump and Tank. These
hoses go through a hose holder that is welded to the
front Rail support that is bolted to tractor frame Rail,
these hose must be run here before connecting
them to Pump and tank (See Figure 10). These are
the pressure and return hoses. The fitting on the
Tank will have plastic ties on them that match the
Plastic ties on the Hoses (See Figure 8 & 9).
Connect these hose to the correct colors, Red
Sleeving to
Pressure, Orange Tank Return from Motor and
Protedt Hoses.
Blue Tank Return from Bypass.
Figure 5
Figure 7
Figure 6
Figure 8
Orange Plastic Tie
Red Plastic Tie
Blue Plastic Tie
Figure 9
Machete (JD-62, 63, 6420 Asy Man) 10/04
Section 8 - 3
© 2004 Alamo Group Inc.