Advertisement
Boom Head Installation / Head Hoses:
1.
With the hoist, lower the Boom (1) down to the Machete head (2). Align the Boom with
the Machete Head Hitch Post (3) Insert the Upper Hitch Pin (4) Thru the Dipper end of the
Boom and the Machete Head Upper Hitch Post. Attach with Washer (5), Nut (6), and Cotter Pin
(13) as shown in Figure 12 .
2.
Align the Lower Linkage (7) of the Boom and insert the Lower Hitch Pin (8) thru the Hitch
Post. Attach with Nut (9) and Bolt (10).
3.
Following Hydraulic Connection Decal on Boom, Attach the Motor Hydraulics (11), To
the Boom and the Motor. Attach the Door Cylinder Hoses (12) from the Boom the Machete
Heads Door Cylinder. Each of these are color coded for ease of identification. Do Not cross
any hose connections, check them RED = Pressure Supply to Motor, Orange = Motor Return
back to Tank, Blue = Motor case drain Back to Tank. Yellow = Rod end of Door Cylinder, Yellow
with White Stripe = Base end of cylinder. If the Head you are useing doesn't have a Door leave
the connection for Door Cicuit capped at the Boom (See Figure 12).
1
11
Orange
Red
Blue
Yellow/White
Yellow
2
FIGURE 12
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
Head Installation 2 WD & 4 WD
5
13
6
3
Section 9 - 5
NOTE: The FML 100H and the
Flail-Axe are attached in the
same fasion as the Machete
Head, however the Flail-Axe
does not have Auxilary/Door
4
Connections (Yellow/ Yellow
and White Hoses) keep these
sealed off.
9
7 8
10
12
Red
Orange
Yellow
Yellow/White
Advertisement
