Advertisement
Frame Rail Installation 2 WD & 4 WD
Tack Welding Frame Rails:
4.
Frame Stiffener Assembly. The frame stiffener is an assembly designed to run under the
Tractor to tie the two Frame Rails together and support each other. The Gusset Rail Support is designed
to stabilize the Frame Rails to the tractor frame. Re-check the left hand and right hand sides to make
sure the alignment is still correct and the tack Welding has been performed.
Front Wheel End
Tack Weld here on both
sides Front and Back only
after alignment
Align Flush with Bottom
of Vertical Tube
RH Rail Stiffener Weldment (RH Side)
Rail Stiffener Tube Crossmember
Figure 39
5.
Locate Mounting Tubes and Hardware. See Figure 31 for breakdown of these components.
A.
There will be one Mounting Tube for each side; these tubes are the same so it will not
matter which is on which side. The Mounting Tubes are the same on either end. (See
Figure 31 - Item 1).
B.
There will be 8 Bar Mounting Straps (Part # 02966639); these straps are the same but
later in the assembly process 4 will have to be cut (See Figure 31 - Item 2 & 2A).
C.
There are 4 Angle Mounts (Part # 02966641), these have two holes in them and when
mounted the hole will be up. (See Figure 31 - Item 5).
D.
There are 8 bolts (Part # 02957039) & Locknuts (Part # 00037200), the bolts are 3/4"
X 10-1/2" Long (See Figure 31 - Item 4).
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
(continued)
Vertical Tube of RH Frame Rail
LH Rail Stiffener Weldment
(LH Side)
Section 4 - 18
C-Clamp Here
Rear Axle End
Horizontal Tube
Gusset Rail Support
Tack Weld Here
after final
assembly only
LH Frame Rail is
Mounted Here
Advertisement
