Advertisement
Timbercat Solenoid Valve to Pump Assembly:
4.
Attach the TimberCat Head
Assembly to the boom using the ex-
isting pins and fasteners.
the hoses to the ports in the boom
according to the Hydraulic Connec-
tion Diagram, shown (See Figure 13
Detail C), and on the decal on the
boom.
Attach the steel cap nuts
(02919600) to the two auxiliary/door
connection ports of the boom, if they
are not already installed. Check
Hoses for correct connections.
There is a decal on the side of the
Boom showing hose connections
(See Figure 14).
Ditcher Head Assembly:
1.
Attach sraight adapter (2) to case
drain port. Then fasten hose (8) to
elbow (1) and attach to straight
adapter (2) --- LEAVE LOOSE. Hose
must be connected at Angles shown
to clear. (See Figure 15)
2
. Attach hoses (3 & 4) on boom end and tighten. (See Figure 15 Boom Side View)
3.
Tighten the fittings on the bottom hose (8).
4.
Attach and tighten all hoses to motor after head is attached.
BOOM END VIEW
Hoses should be angled so
crimp sleeves on hoses
Boom
Angle 45° toward boom
Figure 15
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
Head Installation 2 WD & 4 WD
Attach
Hydraulic Motor Connection
Blue = Case drain
Orange = Return
Red = Pressure
Auxillery Door Connections
Yellow = Rod End of Cyl.
Yellow/White = Butt End of Cyl
Figure 14
BOOM SIDE VIEW
3
4
8
5
1
2
Section 9 - 7
(continued)
Hydraulic Connection
Orange
Red
Boom Head Decal
MOTOR VIEW
Return
Pressure
6
Case
7
Hyd tube
cover on
Blue
Yellow
Yellow
White
Return
Pressure
Case
Advertisement
