Advertisement
Valve Hose to Boom Hose Connections:
1.
Hoses for Door Cylinder, Qty of two, # 4 hoses X 66" Long, one hose (# 02969124) with
Yellow Tie and one hose (# 02979123) with Yellow / White Stripe Tie.
2.
Hoses for Tilt Cylinder, Qty of two, # 6 hoses X 58" Long, one hose (# 02976728) with
Red Tie and one hose (# 02976729) with Red / White Stripe.
3.
Hoses for Dipper Cylinder, Qty of 2, # 6 hoses X 64" Long, one hose (# 02976705) with
Blue Tie and one hose (# 02976706) with Blue / White Stripe Tie.
4.
Hoses for Lift Cylinder, Qty of 2, # 6 hoses X 64" Long, one hose (# 02976709) with Or
ange Tie and one hose (# 02976710) with Orange / White Stripe Tie.
5.
Hoses for Swing Cylinder, Qty of 2, # 6 hoses X 44" long, one hose (# 02976734) with
Green Tie and one hose (# 02976735) with Green / White Stripe Tie.
Valve Hose to Tractor Connections:
1.
Hoses Pressure Supply, ("P" Marked on Valve), Qty of one, # 8 hose X 190" Long, hose
(# 02976714) with Red Tie. This connects to the rear of the Tractor (See Figure 1)
2.
Hose for Tank Return, ("T" Marked on Valve), Qty of one, # 8 hose X 190" Long, hose
(# 02976713) with Orange Tie. This connects to the rear of the Tractor (See Figure 1).
3.
Hose for Load Sense, (Note Marked on Valve See Figure 1) Qty of one, #4 hose X 190"
Long, hose (#02215700). This Hose connects to the rear of the Tractor (See Figure 2)
This Hose cannot be connected till Stack Valve has been modified with New LH End Plate.
Tractor Rear Hydraulic Valve Stack Connections:
Change End Plate, The original JD Factory LH or the RH Valve End Plate (See Figure 2) on the rear
of the Tractor Hydraulic Valve Stack Outlet will have to be changed depending on the tractor s/n. The
New LH Valve End Plate is Part # 02978829. This is done to install a new Valve End Plate with the Load
Sense Port (See Figure 5 and 6). The following steps are for installation of the new Valve End Plate,
if these procedures are not followed damage to the Tractor Hydraulic Outlet could occur. Figure 2 is
standing behind Tractor looking forward and shows the Old End Plate.
Figure 2
LH Valve
End Plate
Tie
Rods
No Ports in JD Original Valve End Plate
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
Hose Connecting Instructions
Pressure Port (Plugged) Tank Return Port (Plugged)
Section 8 - 6
Original LH End Plate Shown
"P"
"T"
RH Valve End
Plate
Tie
Rods
Advertisement
