Advertisement
Frame Rail Installation 2 WD & 4 WD
Counter Weight Installation:
3.
Counter Weight (CWT) Support Rod Installa-
tion. The Counter weight Mounting Bracket will
Connect to the High Frame with a weld on Bracket.
(See Figure 35) The bracket has to aligned with the
Counter Weight Support Rod Notch (See Figure
33). When aligned clamp the Bracket to the High
frame on the LH outer side (See Figure 34).
4.
Weld Counter Weight Bracket and Support
Rod. Weld the Support Rod Bracket to the High
Frame, weld up each side and over the top (See
Figure 89). Counter Weight must be supported to
where it is level during the entire mounting process.
If it is not supportted it will sag after being welded.
Figure 34
Figure 36
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
(continued)
High Frame
CWT Support
Rod Bracket
C-Clamp
Support Rod
Counter Weight
Support Rod
aligned into notch
in Counter Weight
Counter Weight
Support Rod Notch
Figure 33
Weld Starts
Here
Figure 35
Figure 37
Section 7 - 10
Weld Stops
Here
Advertisement
