Advertisement
Frame Rail Installation 2 WD & 4 WD
Frame Rail Pre-Assembly: (continued)
RH & LH Frame Rails. Shown below are example of Frame rails, There is a Right and Left Frame
Rail, They will not interchange from side to side. LH must be mounted on the Left and Right on the Right.
To ID which is which, the easiest way is to look for the Counter Weight Mounting Tubes (See Figure
1 Item 2), these are welded on to the LH Frame Rail Only. The Rail Mounting Pad (See Figure 1 Item
4) is loose and not welded to the front of the Frame Rail untill final assembly.
Figure 1
Item
Part No.
1
02978468
02978469
2
------------
3
-------------
4
02725900
5
02974704
Note:
Item 2 is only welded on the LH Frame Rail. Item 3 is welded to both LH and
RH Frame Rails from the factory. Item 4 will be welded on during assembly
procedures. Do not weld on any components until instructed to do so, then check
instructions carefully because some components are only to be tack welded then
removed to be welded later.
Actual Tube Design may vary from drawing above. Shown above is a
general Frame Rail Weldment. While Frame Rails may be designed different
the mounting process will be the same.
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
4
Qty
Description
1
2 WD Frame Rail Weldment, LH (Shown)
1
2 WD Frame Rail Weldment, RH (Not Shown)
2
Frame CWT Mounting Tube (Welded on LH Frame Rail Only)
2
Rear Mounting Plate (Welded on LH and RH Frame Rail)
2
Front Rail Mounting Pad (not welded to frame rail when recievedl)
2
Stabilizer Strap, (Axle Straps)
Section 4 - 3
5
1
2
3
Advertisement
