Advertisement
Pump / Hydraulic Tank Assembly Instructions
Installing Hydraulic Tank:
.
3
Hydraulic Tank Installation. Using a hoist
to lift the Hydraulic Tank into position (See Figure
30), The Hydraulic Tank will slide in under Pump.
Align the rear two mounting holes of Hydraulic
Tank with the holes in the Tank Mounting Brackets
(See Figure 31). These are the two closest to the
tractor, Snug these two bolts at this time do not
tighten them, as tank will have to move to align
front Bolts. Note, the front Bolts that mount tank
also mount Bumper. Leave the Tank supported by
the Hoist.
4.
Mounting Bumper. When installing the
front bumper, Tank mount Brackets and the Bumper
must all line up together as they share the same
bolts. Start with one side or the other, in Figures
below we started with the LH side (See Figure 32
& 33). There are three bolts on each side (total 6
for both sides). Insert the Bolts, Washers and
Nuts, but do not tighten untill all 6 are installed.
Tighten the 2 rear mounting bolts and the 6 front
mounting bolts (See Figure 31).
5.
Tightening Tank. Makes sure all the Mount-
ing Bolts for the Tank and Bumper are tightened.
Make sure that all Fittings and Hoses are plugged
to prevent contamination from getting into system.
Figure 30
Machete (JD -62,63,6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
(continued)
Filler
Cap
Valve Filter
Figure 28
Figure 29
Figure 31
Section 3 - 11
Valve Assembly
Hydraulic Tank
Assembly
Bumper
Weldment
Tank Mounting
Bracket
Advertisement
