Advertisement
Installing Joystick Mount to Trac-
tor Seat:
1.
Remove Tractor Seat Cushion. Remove
Lower Seat Cushion from Tractor Seat. The Seat
Cushion should have three phillips head screws
across the front edge (See Figure 2). Once these
screws are removed, lift up on the front of the Seat
Cushion which should slide forward and out.
2.
Joystick Bracket mounting holes. The
three mounting holes are already in the Standard
Seat Mounting Plate. If a custom Seat or for some
reason these three holes have to be drilled, use
caution not to drill them in to where the bolts will
interfere with the Tractor Seat Slide Adjustment
Rail.
3.
Bolt Mounting Bracket to Seat. Insert
the three 5/16" Bolts with Flatwashers on them
through the holes in the Seat Plate (See Figure 4).
The Mounting Bracket is under the Seat Plate as
shown in the drawing. Install the three 5/16" Lock-
nuts on the Bolts from the Bottom. Tighten the
three Bolts and nuts.
4.
Re-install Tractor Seat Cushion. Re-
install Tractor Seat Cushion in reverse of step 1.
Test Seat to make Sure that it does not bind when
slid forward or back as adjustment. If there is a
Bind, check and correct problem.
FIGURE 4
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
Joystick Mounting 2 WD & 4 WD
FIGURE 2
FIGURE 3
FIGURE 5
Section 6 - 3
Advertisement
