Advertisement
Frame Rail Installation 2 WD & 4 WD
Re-Install High Frame to Tractor:
8.
Tighten All Frame Mounting Bolts. Tighten all
the Frame Mounting bolts that have only be
snugged till now. Go through and make sure
none are missed.
A. Front Mounting Pad Bolts. There are 4 Bolts on
each Pad the LH and RH, 8 Total (See Figure
22).
B. Frame Stiffener Crossmember. There are 2
bolts on each side or 4 total. Make sure these
bolts have been installed with the nuts on top.
(See Figure 23).
C. Frame Rails to Rear Axles. The Rear of the
frame rails bolt up to the Bottom of the Tractor
Axle Housing. There is also an Axle Strap on
each side which has long bolts through them
from Axle Strap on top down and through the
Frame rail Mount Plate. The RH side also has
the Boom rest bolted on with it and the Axle
Strap bolts go through it. Tighten all of these
bolts at the rear axle of tractor. (See Figure
24 & 25).
D. Check all Bolts for Tightness. Check to make
sure all Frame Mounting bolts and nuts have
been tightened, Also inspect to make sure they
are installed correctly (See Figures 1 through
27).
Tighten LH & RH
Side
Figure 24
Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004 Alamo Group Inc.
(continued)
Tighten LH & RH
Side
Figure 22
Tighten LH & RH
Side
Figure 23
Figure 25
Section 7 - 7
Tighten LH & RH
Side
Advertisement
